Flakes in the water

A one minute tutorial


FLAKES CAN OCCUR WHEN RESIDUE OR BIOFILM IS REMOVED FROM THE HOT TUB.

Use a tube or pipe cleaner to flush your hot tub and then run the pumps on full speed as often as possible… and make sure to remove the filters to
maximise water flow.

After this drain your hot tub, put the filters back and fill it up again.

If you still notice too many flakes… then repeat the process or wait until the filters pick up the left over residue.
Be patient this process takes time.

O-Care, incidentally, was specifically developed to prevent this problem.

A headshot of Natalie Lapierre against a black background
Article by: Natalie Lapierre

We hope you have found this information useful. If you have any further questions or have something to say about it, please waste no time in sending us an email at [email protected] or use the form on our contact page